Back to Products
WECONPLCLX6/AC60/A500 Series IO
LX6V-EMB-ECAT Coupler Module
Description
Up to 16 extension modules
Specifications
| Item | LX6V-EMB-ECAT | LX6V-EM C -ECAT |
|---|---|
| Rated I nput V oltage | DV 24V±10%@100mA (excluding expansion module) |
| Communication I nterface | RJ45×2, EtherCAT communication protocol with performance100Mbps: IN interface is EtherCAT input port; OUT interface is an EtherCAT output port, which is used for connecting the subsequent EtherCAT slave; |
| Transmission D istance | Length of communication line between two nodes≤100m |
| Transmission M edium | Category 5E (cat 5e) cable or above |
| Single AP P rocess D ata | Maximum input and output 1024 bytes |
| Synchronous P eriod | Minimum 125us |
| Allowable I nstantaneous P ower O utage T ime | 10ms |
| Impulse C urrent | ≤ 45A (with maximum module load) |
| Power P rotection | Anti-reverse connection protection, overcurrent protection and surge absorption |
| Maximum N umber of E xpansion M odules | 16 | 32 |
| Firmware U pgrade | Support |
| Serial N umber | Interface | Function D efinition |
| 1 | Signal I ndicator | PWR | Power indicator | Off | No power supply |
| On | When the power supply is on |
| RUN | Running indicator | Off | ECT module is in INIT status |
| Flashing (white) | ECT module is in PreOp status |
| Single flash (white) | ECT module is in Safe-Op status |
| Normally on (white) | ECT module is in Operational status |
| ERR | Communication fault indicator | Off | EtherCAT communication is in normal status |
| Flashing (Red) | EtherCAT communication receives status transition instructions that cannot be executed |
| Single flash (red) | Network disconnection, ECT module synchronization error |
| Normally on (Red) | Watchdog error occurred in EtherCAT communication |
| 2 | USB Communication Interface (Type-C) | Used for single board software upgrade |
| 3 | EtherCAT I nterface | IN: EtherCAT input port |
| OUT: EtherCAT output interface | |
| 4 | 24V power I nput I nterface | Module power input terminal |
| 5 | Expansion M odule I nterface | Connect LX6V Series expansion module |
| 6 | Mounting H ole | 2 places, φ4.5 |
| 7 | DIN R ail F astener |
